update Updated: 11/15/2018
For the FlashForge CreatorPro, you will need to print these files, already oriented as needed. Here are a few recommendations for printing:
File | Material | Layer Height | Supports | Infill | Download |
---|---|---|---|---|---|
STLFlashForgeSuctionHeadV4.STL | ABS | 0.1 | NO | HIGH |
This is your last print without Zimpure!
Unscrew the two screws of the plastic part which holds the filament guide and remove it. Place the FlashForge Suction Head at this place as shown on the picture below. Rescrew these two screws.
Insert the hose into FlashForge CreatorPro holder and plug the other side of the hose into Zimpure.
Here you go, your Zimpure is ready to filter! First, depending on the cooling fan you’re using, you could have to lower it to have a suction rate efficient enough.
Please note that you need to turn your Zimpure ON only after than your CreatorPro has started to print. Please verify how the beginning of the first layer goes. You are now all set up to print safely, without any toxic emissions. Happy safe printing!